The Ohlins STX 46 Adventure rear shock for the BMW R 1150 GS is built to provide controlled damping and predictable traction across mixed surfaces. It is designed for sustained touring use where heat management, stability and comfort matter over long days. The architecture uses a separated oil and gas design to maintain consistent damping in varied conditions.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on damping control and repeatability. On an adventure platform like the R 1150 GS, that translates to calmer chassis behaviour, improved tyre contact and confidence when conditions change quickly.

Who this shock is for

  • BMW R 1150 GS riders wanting more composed rear-end control for adventure touring
  • Riders who regularly vary load with luggage or a pillion and want adjustability to suit
  • Those who prefer a rebuildable premium shock designed for ongoing service life

Shock design & features

This is a monotube shock using a separated oil and gas layout for stable damping performance during extended riding. It is part of the STX 46 Adventure family, aimed at maintaining control and comfort on rougher roads and tracks without sacrificing on-road feel.

Tuning controls

Adjustment is provided for rebound damping, along with a remote hydraulic spring preload adjuster to suit changing loads. These controls allow you to balance comfort, support and rear ride behaviour to match your riding and luggage requirements.

Before you install

  • Set sag and preload for your typical riding load before making damping changes
  • Check clearance around the remote preload adjuster location and hose routing
  • After installation, re-check fastener torque and verify smooth suspension movement through full travel

Serviceability & lifecycle

The shock is designed to be serviced to keep performance consistent over time. Periodic inspection and oil/seal service helps maintain damping quality, especially for regular off-road or heavily loaded touring use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM550
Model # S46DR1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 383.0
Spring Rate Standard 160.0 N/mm
Type Code S46DR1S
Stroke Metal to Metal (mm) 63.0
Product Family STX 46 Adventure
Fitted Spring 01095-64

More From This Category