The Ohlins HO801 STX 46 Adventure rear shock is built to improve control and comfort on the Honda VFR800FI when conditions and loads vary. It’s designed for consistent damping support across rougher surfaces and longer days in the seat. External adjusters let you tune the feel to suit your riding and the gear you carry.

Ohlins | Made to race, perfected to ride

Ohlins suspension focuses on stable chassis behaviour and predictable feedback. This rear mono shock is intended to give the VFR800FI better composure and ride quality in adventure and touring use.

Who this shock is for

  • Riders using the VFR800FI for adventure-style touring on mixed road surfaces
  • Owners who regularly add luggage or carry a pillion and want suspension that can be set up accordingly
  • Anyone wanting clearer adjustability and more consistent damping support than a tired original shock

Shock design & features

This is an Ohlins STX 46 Adventure rear shock with a monotube layout and a separating piston design to keep oil and gas separated for more consistent damping. It’s a direct-fit unit for the rear position and is supplied with an Ohlins spring as listed for this model.

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Hydraulic spring preload adjustment for quick load changes

Before you install

  • Set sag and preload for your typical riding load (solo, luggage, or pillion)
  • Start from the factory baseline settings supplied with the shock, then adjust rebound and compression methodically
  • Inspect linkage and mounting hardware condition during installation, as worn bearings can mask suspension improvements

Serviceability/lifecycle

Like all performance shocks, this unit is designed to be serviced to maintain damping consistency over time. Regular servicing helps keep the internal oil condition and seal performance where they should be, especially when used in harsher adventure and touring conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO801
Model # S46HR1C1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 325.0
Spring Rate Standard 150.0 N/mm
Type Code S46HR1C1S
Stroke Metal to Metal (mm) 58.0
Product Family STX 46 Adventure
Fitted Spring 01092-59

More From This Category