The Ohlins STX 46 Street rear shock for the BMW F 800 S and F 800 ST is built to improve chassis control and tyre contact on real roads. It uses a gas-backed damping design to help maintain consistent feel as conditions and temperatures change. This unit is intended as a direct-fit rear mono shock replacement with a focus on controlled, predictable suspension response.

Ohlins | Made to race, perfected to ride

Ohlins street suspension is developed from the same engineering approach used in competition, then tuned for everyday riding. The aim is clear feedback, stability and control without relying on overly stiff springing. On the F 800 platform, that translates to improved composure through corners and better support under braking and acceleration.

Shock design & features

This STX 46 Street shock is an oil/gas separated design, using gas pressure to help reduce cavitation and maintain damping consistency. The architecture is aimed at stable damping performance across varying road surfaces and sustained riding.

Tuning controls

This rear shock includes damping adjustment for rebound. It also features length adjustment to fine-tune ride height and chassis attitude. These adjustments allow you to balance stability, turn-in behaviour and traction to suit your riding style and typical road conditions.

Base setup (factory preset)

Ohlins supplies this unit with a baseline setting intended to suit the standard fitment and typical street use. If you change load (luggage or passenger) or want a different feel, small adjustment changes can be used to tailor response while keeping the suspension working in its intended range.

Before you install

Confirm fitment for BMW F 800 S and F 800 ST and check the supplied spring is correct for your application. After installation, set sag and verify clearance through the full range of motion. If you change ride height using the length adjuster, re-check handling balance and stability.

Serviceability/lifecycle

Like any performance shock, this unit is designed to be serviced to maintain oil condition and internal wear parts over time. Regular servicing helps preserve damping consistency and protects long-term performance as kilometres and heat cycles accumulate.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM707
Model # S46DR1LS
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 345.5 +6/-6
Spring Rate Standard 210.0 N/mm
Type Code S46DR1LS
Stroke Metal to Metal (mm) 49.5
Product Family STX 46 Street
Fitted Spring 01093-89
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category