The Ohlins BM942 STX 46 Adventure rear shock is built for the BMW R 1150 GS, targeting controlled damping and consistent support across mixed surfaces. It is designed for sustained adventure and touring use where stability matters over changing loads and rougher terrain. This unit is intended to improve chassis composure and reduce rider workload on long days.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on damping control, durability and serviceability. This rear shock follows that approach with an architecture suited to adventure and touring demands.

Shock design & features

This is a monotube shock with a separated oil/gas layout, aimed at maintaining damping consistency when conditions get rough. The STX 46 Adventure family is intended for reliable performance across corrugations, rocky climbs and long-distance use, including when carrying luggage and a pillion.

Tuning controls

The BM942 provides rebound damping adjustment and compression damping adjustment for tailoring control and comfort. It also includes hydraulic spring preload adjustment to help you compensate for load changes without disassembly.

Base setup (factory preset)

Supplied with an Ohlins baseline setting intended to suit the standard application. Fine-tuning is typically done by balancing preload for ride height and feel, then adjusting damping to manage support and compliance for your terrain and load.

Before you install

  • Confirm fitment for BMW R 1150 GS and your specific model year/variant before installation.
  • Set sag and preload for your typical load (solo, luggage, pillion) prior to making damping changes.
  • Check clearances and hose routing for the preload adjuster during installation.

Serviceability/lifecycle

As with Ohlins units, the shock is designed to be serviced to maintain performance over time. Periodic inspection and servicing helps keep damping consistent and reduces wear in seals and oil.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM942
Model # S46DR1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 375.5
Spring Rate Standard 140.0 N/mm
Type Code S46DR1S
Stroke Metal to Metal (mm) 55.5
Product Family STX 46 Adventure
Fitted Spring 01095-54

More From This Category