The Ohlins BM836 rear shock is a street-focused replacement for BMW R 100 GS and R 100 PD models, built around Ohlins STX 46 architecture. It is designed to deliver consistent damping control and improved chassis stability across everyday road use and light touring. The construction uses a separated oil/gas layout to help maintain damping consistency as conditions change.

Ohlins | Made to race, perfected to ride

Ohlins road and adventure products draw on proven suspension engineering principles: controlled damping, predictable support, and repeatable adjustability. The goal is confidence and composure rather than harshness, with a setup that can be tailored to rider preference and load.

Shock design & features

  • STX 46 rear shock design intended for road and mixed surface riding.
  • Separated oil/gas design to support stable damping behaviour and reduced fade over longer rides.
  • Direct-fit rear mono application for the listed BMW models.

Tuning controls

  • Rebound damping adjustment to tune how quickly the rear settles after bumps and weight transfer.
  • Spring preload adjustment to suit rider weight, luggage, and ride height preference.

Base setup (factory preset)

This unit is supplied with an Ohlins-recommended base valving and spring fitment for the application. Fine-tuning is typically done by setting preload for sag, then adjusting rebound to match tyre choice, road surface, and riding pace.

Before you install

  • Confirm the application is correct for your BMW R 100 GS or R 100 PD and rear mono mounting.
  • Inspect linkage/bushings and mounting hardware condition before fitting a new shock.
  • After installation, re-check fastener torque and verify free movement through suspension travel.

Serviceability/lifecycle

Ohlins shocks are built to be serviced and reconditioned. Regular servicing helps keep damping consistent and allows internal wear items and fluid to be renewed over the life of the shock.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM836
Model # S46DR1S
Barcode # BM836
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 495.0
Spring Rate Standard 80.0 N/mm
Type Code S46DR1S
Stroke Metal to Metal (mm) 80.0
Product Family STX 46 Adventure
Notes Rear
Fitted Spring 00698-24
Spring Colour Yellow

More From This Category