The Ohlins BM842 STX 36 Supersport is a front mono shock for the BMW R 1100 S, developed to deliver controlled damping and consistent chassis behaviour. It uses a gas-pressurised design to maintain damping stability as conditions change. Built around Ohlins’ proven Supersport architecture, it’s intended for riders who value clear feedback and predictable front-end support.

Ohlins | Made to race, perfected to ride

Ohlins suspension is designed with a focus on damping control, traction and stability. The STX 36 Supersport range applies that approach to performance road and track use where repeatability and feel matter.

Who this shock is for

  • BMW R 1100 S riders wanting a higher level of front-end control and confidence
  • Track-day and fast-road riders who need consistent damping under demanding use
  • Owners looking for a dedicated performance front mono shock solution

Shock design & features

This is a gas-pressurised shock, with oil and gas managed to support consistent damping performance. The STX 36 Supersport construction is aimed at delivering stable behaviour under braking and through direction changes, with a focus on usable feedback rather than harshness.

Tuning controls

The BM842 provides adjustable rebound and adjustable compression damping, allowing you to balance comfort, support and grip for your tyres, riding pace and road or track surface. These independent damping adjustments help you tune how the front responds to bumps, braking load and mid-corner attitude.

Before you install

Confirm fitment for your BMW R 1100 S and inspect associated mounting hardware during installation. After fitting, set sag and then fine-tune rebound and compression in small steps so you can clearly feel the effect of each change.

Serviceability/lifecycle

Like all performance shocks, regular servicing helps maintain damping consistency and component life. Keeping the unit clean and having it inspected and serviced at appropriate intervals will support long-term performance.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM842
Model # S36PR1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front Mono
Shock Length Eye to Eye (mm) 318.0
Spring Rate Standard 57.0 N/mm
Type Code S36PR1
Stroke Metal to Metal (mm) 70.0
Product Family STX 36 Supersport
Notes Front
Fitted Spring 00180-44
Spring Colour Yellow

More From This Category