The Ohlins DMX0000 is a TTX 30 rear shock designed as a direct-fit replacement for KTM 50 SX and SX-E 5 models. Built around Ohlins twin-tube damping, it aims to deliver consistent control and a predictable feel as conditions change. It is supplied without a spring, with fitment notes provided for the correct spring series.

Ohlins | Made to race, perfected to ride

Ohlins TTX technology uses a twin-tube architecture to help maintain damping stability and control. This unit is intended for off-road competition use where repeatability and tuning flexibility matter.

Shock design & features

  • TTX 30 twin-tube rear shock design
  • Fully serviceable and rebuildable construction
  • No spring supplied (spring sold separately; see notes)

Tuning controls

This shock provides external compression and rebound adjustment to tailor the feel for rider preference and track conditions.

Base setup (factory preset)

The DMX0000 is delivered with an Ohlins factory baseline setting. Final setup will depend on the spring selection and the bike’s use, so allow time to set sag and confirm damping balance after installation.

Before you install

  • Confirm the correct spring series per the fitment notes (spring not included).
  • Check that all mounting hardware and clearances match the KTM 50 SX / SX-E 5 application before riding.
  • Plan for periodic servicing to keep performance consistent over time.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DMX0000
Model # T30PR1C1W
Barcode # DMX0000
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Shock Length Eye to Eye (mm) 276.0
Spring Rate No Spring/s Supplied
Type Code T30PR1C1W
Stroke Metal to Metal (mm) 68.0
Product Family TTX 30
Notes 00181- spring series *Replaces KT 1397*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category