The Ohlins DMX0106 STX 46 MX is a rear shock unit designed for KTM 85 SX fitment. Built around Ohlins motocross damping know-how, it focuses on consistent rear-wheel contact and predictable chassis behaviour across changing track conditions. Supplied without a spring, it’s intended to be matched with the correct rate for the rider and use.

Ohlins | Made to race, perfected to ride

STX 46 MX rear shocks are developed for motocross and enduro applications where control and repeatability matter. The DMX0106 is a direct replacement-style unit aimed at riders who want more tuning range and serviceability than a basic OEM-style shock.

Shock design & features

  • STX 46 MX rear shock architecture for motocross use
  • Oil and gas separation via an external reservoir for more consistent damping under sustained use
  • Serviceable internal design with Ohlins replacement parts support
  • Supplied with no spring fitted (spring selection required)

Tuning controls

This shock provides external adjustment for compression and rebound damping, allowing you to tailor feel for track surface, grip level and rider preference. Spring preload is adjusted once the correct spring is fitted.

Base setup (factory preset)

The DMX0106 is supplied with an Ohlins baseline valving setup intended for KTM 85 SX applications. Final setup should be confirmed once the correct spring rate is installed and sag is set.

Before you install

  • Confirm KTM 85 SX model/year compatibility before fitment
  • Select the correct spring (not supplied) as noted for this model
  • Check linkage bearings and mounting hardware condition during installation

Serviceability/lifecycle

As a fully serviceable Ohlins unit, the shock is designed to be maintained with routine oil and wear-part replacement to keep damping consistent. Regular servicing is recommended for motocross use where contamination and heat cycles are higher.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DMX0106
Model # S46PR1C2Q1W
Barcode # DMX0106
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 392.0
Spring Rate No Spring/s Supplied
Type Code S46PR1C2Q1W
Stroke Metal to Metal (mm) 92.0
Product Family STX 46 MX
Notes 00698- spring series *Replaces KT 2190*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

Related products

More From This Category