The Ohlins DMX0213 is a rear shock unit from the TTX Flow DV range for selected KTM 2-stroke MX models. It is built around a separated oil/gas damping layout to maintain consistent control as conditions change. With external adjusters for both compression and rebound damping, it supports practical tuning for track and rider preference.

Ohlins | Made to race, perfected to ride

Ohlins off-road suspension is developed with a focus on repeatable damping behaviour and clear feedback at the tyre contact patch. The DMX0213 follows that approach with a design intended to keep damping stable through varied loads and impacts.

Shock design & features

  • Rear mono shock configuration for KTM fitment listed in the product name
  • TTX Flow DV product family architecture
  • Separated oil/gas internal design to help reduce fade and maintain damping consistency

Tuning controls

  • Compression damping adjustment
  • Rebound damping adjustment

Before you install

  • No spring is supplied; spring selection is required before fitment
  • Confirm spring series and any preload adjuster requirements noted for this unit prior to assembly
  • Check the note that this part has been replaced by DMX 1213 when planning procurement

Serviceability/lifecycle

This is a rebuildable Ohlins shock designed for routine servicing with the recommended Ohlins shock oil. Keeping service intervals consistent helps preserve damping performance and seal life, particularly in off-road use.

Is it right for you?

If you want a quality Ohlins rear shock with separated oil/gas damping and straightforward external compression and rebound adjustability for MX or enduro use, the DMX0213 suits the role. If you specifically need the latest superseding part number, note the replacement listing referenced in the product notes.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DMX0213
Model # T46PR1C2W
Barcode # DMX0213
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 457.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C2W
Stroke Metal to Metal (mm) 137.0
Product Family TTX Flow DV
Notes 06310- spring series. Preload adjuster 15000-02 fits this shock. *Replaced by DMX 1213*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category