The Ohlins TTX Flow DV rear shock for the Triumph TF250-X is built for consistent damping control and clear chassis feedback in motocross and enduro use. It uses a gas-pressurised, oil/gas separated design to help maintain performance during demanding riding. This unit is supplied without a spring, allowing the correct rate to be selected for your rider weight and application.

Ohlins | Made to race, perfected to ride

Developed from Ohlins competition suspension experience, this rear shock is intended to provide controlled traction and stability when the pace increases. The TTX architecture is designed to deliver predictable damping behaviour through a wide range of conditions.

Shock design & features

  • TTX Flow DV rear shock for off-road use
  • Gas-pressurised, oil/gas separated construction (not an emulsion shock)
  • Configured for a rear mono shock application

Tuning controls

This shock provides external adjustment for compression and rebound damping, enabling changes to suit track conditions, tyre choice, and rider preference.

Before you install

  • Spring is sold separately; select the correct spring before fitting
  • Confirm fitment for Triumph TF250-X and check clearance with your linkage and ride height settings
  • Use the recommended Ohlins shock oil specified for the unit during service

Serviceability/lifecycle

Ohlins shocks are designed to be serviceable with routine maintenance to keep damping consistent. Plan periodic inspection and oil service based on riding conditions and hours of use.

Is it right for you?

If you want a tunable rear shock with separate compression and rebound adjustment and a pressurised, separated gas system for consistent feel, this unit suits that brief. Note: this part number is listed as replaced by DMX 1218.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DMX0218
Model # T46PR1C2W
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 470.0
Type Code T46PR1C2W
Stroke Metal to Metal (mm) 128.0
Product Family TTX Flow DV
Notes *Replaced by DMX 1218*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category