The Ohlins DMX1308 is a rear mono shock from the TTX Flow DV family for select KTM EXC models. Built around Ohlins’ twin-tube damping architecture, it is designed to deliver stable, consistent damping across a wide range of conditions. This unit uses a gas-pressurised, oil/gas separated design to help maintain damping consistency during demanding riding.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on damping control, durability and repeatable setup changes. The TTX Flow DV platform is intended for riders chasing predictable traction and clear chassis feedback in enduro and off-road use.

Shock design & features

  • TTX twin-tube damping layout for controlled, consistent damping behaviour
  • Gas-pressurised, oil/gas separated construction to support stability under heat and load
  • Rear mono shock configuration for KTM EXC fitment listed in the product name

Tuning controls

This shock provides external damping adjustment for both compression and rebound, allowing you to tailor feel for traction, support and stability. Setup changes can be used to balance comfort against chassis control depending on terrain and pace.

Before you install

  • Spring is sold separately (refer to the notes for this listing)
  • A preload adjuster is noted as compatible with this shock (15000-03)
  • This part is noted as replaced by DMX 0308

Serviceability/lifecycle

Like all performance dampers, regular servicing helps maintain consistent damping and seal life. Use the recommended Ohlins shock oil specified for this unit (01304-).

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DMX1308
Model # T46PR1C2Q1W
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 403.0
Type Code T46PR1C2Q1W
Stroke Metal to Metal (mm) 93.0
Product Family TTX Flow DV
Notes Preload adjuster 15000-03 fits this shock *Replaces by DMX 0308*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category