The Ohlins STX 46 Street rear shock for Ducati Monster models is built to improve control and consistency for real-world road riding, with capability for occasional track use. It uses a pressurised, oil/gas separated design to keep damping stable as conditions and pace change. The result is clearer chassis feedback and more predictable behaviour through braking, cornering and acceleration.

Ohlins | Made to race, perfected to ride

Ohlins road shocks draw on the same engineering approach used across the brand’s competition programs, tuned for street durability and ride quality. This unit is intended as a direct-fit rear mono shock replacement for the listed Ducati Monster applications.

Shock design & features

  • STX 46 Street architecture focused on consistent damping and tyre contact.
  • Pressurised, oil/gas separated internal layout to help reduce fade during extended riding.
  • Built as a complete replacement rear shock assembly for the original unit.

Tuning controls

  • Rebound damping adjustment to refine how the rear settles and recovers after bumps and load changes.
  • Compression damping adjustment to tune support under braking, corner entry and acceleration.
  • Spring preload adjustment to set ride height and sag for rider load and usage.

Base setup (factory preset)

This shock is supplied with an Ohlins spring fitted and a baseline damping setup from Ohlins. Use the factory settings as your starting point, then adjust one change at a time to match tyres, road conditions and riding style.

Before you install

Confirm the application list matches your exact Ducati Monster model and year, and inspect linkage bearings and mounting hardware while the shock is out. After installation, set sag and re-check fasteners after the first rides to ensure everything has bedded in correctly.

Serviceability/lifecycle

Ohlins shocks are designed to be serviced and reconditioned. Periodic servicing helps maintain damping performance and keeps wear items, seals and oil in good condition over the life of the unit.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU046
Model # S46PR1C1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 305.0
Spring Rate Standard 100.0 N/mm
Type Code S46PR1C1S
Stroke Metal to Metal (mm) 66.0
Product Family STX 46 Street
Fitted Spring 01091-34
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category