The Ohlins DU469 TTX GP rear shock is built for Ducati 899 and 959 Panigale riders chasing consistent damping control and clear feedback. Developed from Ohlins race suspension practice, it is designed to keep the chassis settled under hard use and to support confident corner entry and exit. This unit uses a gas-pressurised, oil/gas separated architecture to help maintain damping consistency through longer sessions.

Ohlins | Made to race, perfected to ride

As part of the TTX GP family, this rear mono shock focuses on stable damping behaviour and predictable response across a wide tuning range. It is intended for performance riding where repeatability and feel matter as much as outright grip.

Who this shock is for

  • Riders using the 899 or 959 Panigale on spirited road rides and regular track days
  • Owners wanting more tuning range than standard suspension can offer
  • Anyone prioritising braking stability, mid-corner support and drive off the corner

Shock design & features

  • Gas-pressurised, oil/gas separated design for consistent damping behaviour
  • Rear mono configuration suited to the Ducati 899/959 chassis layout
  • Race-derived internal layout aimed at precise control and clear feedback

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Spring preload adjustment

Before you install

  • Confirm the application and fitment for your exact model and year before ordering
  • Set sag and baseline damping after installation to suit your weight, tyres and riding use
  • Note: this model is listed as replaced by DU 569

Serviceability/lifecycle

Like all high-performance shocks, this unit is designed to be serviced. Regular inspection and periodic oil/seal service helps keep damping consistent and protects internal components, especially with frequent track use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU469
Model # T36PR1C1L
Barcode # DU469
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 312.0 +4/-8
Spring Rate Standard 80.0 N/mm
Type Code T36PR1C1L
Stroke Metal to Metal (mm) 65.0
Product Family TTX GP
Notes **Replaced by DU 569**
Fitted Spring 01092-24
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category