The Ohlins TTX GP rear shock for Ducati Panigale V4 models is built around the TTX twin-tube damping concept used in high-level road racing. It is intended to deliver consistent damping behaviour under demanding loads, with clear feedback for chassis balance changes. This unit is supplied as a rear mono shock for the applications listed.

Ohlins | Made to race, perfected to ride

TTX GP is Ohlins’ focused platform for riders chasing a race-oriented suspension package. The design targets stability under braking and support through high-load cornering, while maintaining sensitivity for grip.

Who this shock is for

  • Ducati Panigale V4 riders wanting a dedicated Ohlins rear shock solution for performance riding
  • Owners looking for a tuning-capable mono shock to refine rear grip and chassis attitude
  • Riders prioritising predictable damping feel and consistency during hard use

Shock design & features

  • TTX twin-tube architecture with separated oil and gas to help maintain damping consistency
  • Rear mono shock configuration for the Ducati Panigale V4, V4 R, V4 S, V4 S Corse and V4 Speciale fitments listed
  • Race-derived internal layout aimed at stability and traction control through the stroke

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Spring preload adjustment
  • Length/ride-height adjustment

Before you install

  • Confirm model and variant compatibility against your exact Panigale V4 specification
  • Set sag and baseline adjusters before making track or road changes, altering one variable at a time
  • Inspect linkages and mounting hardware condition during installation to ensure correct function

Serviceability/lifecycle

This Ohlins shock is designed to be serviced and reconditioned to maintain performance over time. Regular oil and seal service intervals should be based on how and where the bike is used.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU468
Model # T36PR1C1LS
Barcode # DU468
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 310.0 +4/-2
Spring Rate Standard 95.0 N/mm
Type Code T36PR1C1LS
Stroke Metal to Metal (mm) 63.0
Product Family TTX GP
Fitted Spring 21040-31
Spring Colour Yellow

More From This Category