The Ohlins FGK238 NIX 30 fork cartridge kit is designed to improve front-end control and consistency on the Yamaha YZF R6. It focuses on clearer feedback through braking and corner entry, helping the bike feel more composed and predictable. With adjustable damping circuits, it allows you to refine the feel to suit your riding and conditions.

Ohlins | Made to race, perfected to ride

Ohlins suspension components are developed to deliver controlled damping and repeatable performance. The FGK238 NIX 30 cartridge is built to provide a communicative front end without compromising ride quality.

Who this kit is for

  • YZF R6 riders chasing improved braking stability and mid-corner feel
  • Riders who want a more controlled, confidence-inspiring front end
  • Street riders who also do occasional track riding

Shock design & features

  • NIX 30 front fork cartridge kit (FGK238)
  • Premium internal components intended for consistent damping performance
  • Designed to improve front-end feedback and overall control

Tuning controls

  • Separate compression adjustment
  • Separate rebound adjustment
  • Allows fine-tuning for different riding styles and conditions

Is it right for you?

If you want a more composed and communicative front end with the ability to tune damping to your preference, the FGK238 NIX 30 cartridge kit is a suitable option for the Yamaha YZF R6. It is aimed at riders prioritising feel, stability and control rather than a simple cosmetic upgrade.

Before you install

  • Confirm model compatibility for your specific Yamaha YZF R6 variant before fitting
  • Professional installation is recommended to ensure correct setup and adjustment access
  • After installation, allow time to set damping to suit your tyres, riding conditions and preferences

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FGK238
Model # NIX 30
Barcode # FGK238
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Front cartridge
Spring Rate No Spring/s Supplied
Type Code NIX 30
Fork Length (mm) 744.0
Stroke Metal to Metal (mm) 115.0
Product Family NIX 30
Notes 08790-xx series spring Not 2017
Fitted Spring Sold separately, see notes.

More From This Category