The Ohlins STX 46 Street rear shock for the Honda CB1000R is built to improve chassis control and ride consistency on the road. It uses a gas-pressurised damping system aimed at stable behaviour under braking and acceleration. Designed as a rear mono shock, it focuses on predictable traction and clear feedback for real-world street riding.

Ohlins | Made to race, perfected to ride

Ohlins road suspension is developed from proven damping principles and refined for street conditions. The result is a controlled, confidence-inspiring feel without relying on harsh springing or overly stiff settings.

Shock design & features

  • STX 46 Street architecture with gas-pressurised damping for consistent performance
  • Rear mono shock layout for the Honda CB1000R
  • Designed to support stability under braking and improve drive out of corners

Tuning controls

This shock includes rebound damping adjustment to tailor how quickly the rear recovers after bumps and load changes. It also includes an adjuster for spring preload to set sag for rider weight and luggage.

Base setup (factory preset)

The shock is supplied with an Ohlins-fitted spring and a baseline setting intended to suit typical street use. Fine-tuning rebound and preload is recommended after installation to match your tyres, load and preferred feel.

Before you install

  • Confirm correct fitment for your Honda CB1000R and check clearance around linkages and exhaust
  • Set rider sag via preload, then adjust rebound to control wallow or harshness
  • Inspect bearings and linkage condition, as worn components can mask suspension improvements

Serviceability/lifecycle

Like other performance dampers, this unit is designed to be serviced to maintain damping quality over time. Regular inspection and periodic oil and seal service helps keep performance consistent.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO009
Model # S46DR1
Barcode # HO009
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 310.0
Spring Rate Standard 160.0 N/mm
Type Code S46DR1
Stroke Metal to Metal (mm) 47.0
Product Family STX 46 Street
Fitted Spring 01095-64
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category