The Ohlins HO340 TTX GP rear shock is built around race-derived damping control for the Honda CBR1000RR. It is designed to deliver consistent feel and stable chassis behaviour when you are pushing hard on track. The TTX architecture uses a pressurised, separated oil and gas system to help maintain damping stability through demanding sessions.

Ohlins | Made to race, perfected to ride

TTX GP units are developed from circuit use where repeatability and clear feedback matter. The HO340 is a rear mono shock intended for riders chasing controlled support and predictable traction at higher speeds.

Who this shock is for

  • Track riders wanting a dedicated rear suspension package for the CBR1000RR
  • Riders who tune suspension and want clear, repeatable adjustment changes
  • Anyone looking for a rear shock with stable damping behaviour under heat and load

Shock design & features

This is a TTX GP rear shock with a pressurised system that keeps oil and gas separated to support consistent damping. The design focuses on maintaining control during heavy braking, direction changes, and corner exit drive.

Tuning controls

The HO340 provides external damping adjustments for both rebound and compression. Compression is separated into low-speed and high-speed control, allowing you to tune support and bump response independently, alongside rebound for balance and drive.

Before you install

This shock is model-specific for rear fitment on the Honda CBR1000RR. Confirm clearance and linkage condition before installation, and plan to set rider sag and damping to suit your tyres, pace, and track surface after fitting.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO340
Model # T36PR1C1LS
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 302.0 +4/-2
Spring Rate Standard 105.0 N/mm
Type Code T36PR1C1LS
Stroke Metal to Metal (mm) 60.0
Product Family TTX GP
Notes Type TTX GP
Fitted Spring 21040-36

More From This Category