The Ohlins HO011 STX 36 Twin shock set is a rear suspension upgrade designed for the Honda CB1100EX, including the Thailand version. Built around Ohlins road-focused damping architecture, it targets improved control and stability without compromising everyday ride quality. This unit uses a gas-pressurised design to maintain consistent damping during extended riding.

Ohlins | Made to race, perfected to ride

Developed from Ohlins competition experience and adapted for street use, the STX 36 Twin format suits twin-shock motorcycles that benefit from modern damping control and dependable consistency. It is intended as a direct-fit solution for the specified CB1100EX applications.

Who this shock is for

Suited to riders who want clearer chassis feedback and more controlled behaviour through braking, corner entry and corner exit. It is also a strong option for those carrying varied loads or riding across mixed road conditions where adjustability helps tailor the bike’s balance.

Shock design & features

This is a gas-pressurised twin-shock arrangement with separated oil and gas to help reduce fade and keep damping stable as temperatures rise. The STX 36 Twin family is designed to deliver controlled response and predictable grip, with valving aimed at street performance and stability.

Tuning controls

Adjustability includes rebound damping and a single combined compression damping adjuster. These controls allow you to refine how the rear settles after bumps and how it resists compression under braking, acceleration and road impacts.

Before you install

Confirm fitment for the Honda CB1100EX (including Thailand version) and check overall shock condition of mounts and bushes before installation. After fitting, set sag and revisit damping settings once you have a baseline ride on your usual roads.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO011
Model # S36DR1L
Barcode # HO011
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 362.0 +5/-5
Spring Rate Standard 18.0 - 27.0 N/mm Progressive
Type Code S36DR1L
Stroke Metal to Metal (mm) 83.0
Product Family STX 36 Twin
Fitted Spring 21211-03 (C)

More From This Category