The Ohlins HO147 STX 36 Twin shock is a rear suspension unit designed for the Honda CB 1300. Built around Ohlins road and race development, it focuses on consistent damping control and clear feedback at the rear tyre. This twin-shock layout is intended to improve stability and traction across a wide range of real-world riding conditions.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a strong emphasis on damping quality, durability, and repeatable performance. The HO147 is part of the STX 36 Twin family, offering a modern damper architecture in a twin-shock format suited to the CB 1300.

Shock design & features

  • STX 36 Twin rear shock configuration for Honda CB 1300
  • Oil and gas separated design to support consistent damping during sustained use
  • Designed to provide improved chassis control and rear-end support

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Spring preload adjustment

Before you install

  • Confirm application and mounting orientation for the Honda CB 1300 rear twin-shock position
  • Set sag and preload correctly before making damping changes
  • Make one change at a time and test to keep tuning consistent

Serviceability/lifecycle

This Ohlins unit is designed to be serviced to maintain damping performance over time. Periodic inspection and servicing helps keep oil condition, seals, and damping behaviour consistent.

Is it right for you?

If you want a serviceable, adjustable Ohlins rear twin-shock solution for the CB 1300, the HO147 suits riders who value controlled damping and the ability to tune rebound, compression, and preload for load, road, and riding style.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO147
Model # S36PR1C1LB
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 310.0 +10/-0
Spring Rate Standard 41.0 N/mm
Type Code S36PR1C1LB
Stroke Metal to Metal (mm) 71.0
Product Family STX 36 Twin
Fitted Spring 00180-57
Spring Colour Yellow

More From This Category