The Ohlins HO343 STX 36 scooter rear shock pair is built for the Honda Wave 125i, focusing on controlled damping and clear chassis feedback. It uses a gas-pressurised damping system to help maintain consistency as conditions change. This is a rear twin-shock set intended for riders who want more composure and adjustability from their suspension.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing experience, the STX 36 Scooter family brings that approach to everyday scooter and underbone platforms. The aim is stable support under braking and predictable grip through varied road surfaces.

Who this shock is for

Suited to Honda Wave 125i riders chasing improved stability, traction and a more planted feel compared with basic suspension. A good match for riders who want to tune the rear for load changes and riding style rather than accept a one-size setting.

Shock design & features

This model uses a gas-pressurised design to promote consistent damping behaviour. It is a rear twin configuration, supplied as a matched pair, designed to improve chassis control and rear-wheel contact.

Tuning controls

Provides adjustable compression and rebound damping, allowing you to balance support and comfort while tailoring how the rear responds over bumps, during braking, and on corner exit.

Before you install

Confirm compatibility with your exact Honda Wave 125i variant and ensure all mounting hardware and clearances match your current setup. After installation, set sag and make small, methodical damping changes so you can clearly feel the effect of each adjustment.

Serviceability/lifecycle

Ohlins shocks are designed to be maintained and serviced to keep performance consistent over time. Periodic inspection and servicing helps preserve damping quality and extend usable life.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO343
Model # S36PR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 319.5
Spring Rate Standard 11.0 - 15.0 N/mm Progressive
Type Code S36PR1C1
Stroke Metal to Metal (mm) 84.5
Product Family STX 36 Scooter
Fitted Spring 60240-02
Rec. Ohlins Oil 01309-

More From This Category