The Ohlins STX 36 rear shock pair for the Honda PCX 150 is built to improve suspension control and consistency in everyday scooter use. The design focuses on stable damping performance and clearer feedback from the rear end. Suited to riders who want a more controlled chassis feel without compromising practicality.

Ohlins | Made to race, perfected to ride

Ohlins suspension is engineered around controlled damping and repeatable performance. This STX 36 scooter setup applies that approach to the PCX 150, aiming for improved stability and confidence across changing road conditions.

Who this shock is for

  • Honda PCX 150 riders looking for more composed rear suspension behaviour.
  • Commuters and weekend riders who want clearer feel and better control over bumps and braking inputs.
  • Owners who prefer a matched rear pair for balanced response side to side.

Shock design & features

This is a gas-pressurised monotube-style rear shock pair with an oil/gas separated layout for consistent damping. It uses Ohlins STX 36 scooter architecture intended to keep response predictable as conditions change.

Tuning controls

Rebound damping adjustment is provided, allowing you to tailor how quickly the rear suspension returns after compression. This helps balance comfort, traction feel and chassis stability to your preference and load.

Before you install

  • Confirm fitment for Honda PCX 150 and rear twin shock configuration before installation.
  • Set sag and rebound to suit rider weight and typical cargo/passenger use.
  • After installation, re-check fasteners and clearances once the scooter has been ridden.

Serviceability/lifecycle

Ohlins shocks are designed to be maintained. Periodic servicing helps keep damping consistent and extends service life, particularly for year-round commuting use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO810
Model # S36PR1
Barcode # HO810
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 348.0
Spring Rate Standard 12.0 - 19.0 N/mm Progressive
Type Code S36PR1
Stroke Metal to Metal (mm) 104.0
Product Family STX 36 Scooter
Fitted Spring 60360-02
Spring Colour Yellow

More From This Category