The Ohlins HO839 STX 36 is a rear scooter shock developed to improve damping control and chassis behaviour on the Honda Foresight FEZ 250. It uses a gas-pressurised damping system to help maintain consistency as conditions change. The focus is predictable response and clearer feedback for everyday road use.

Ohlins | Made to race, perfected to ride

Built from Ohlins suspension development aimed at stable handling and repeatable performance. The STX 36 scooter platform is designed to deliver controlled movement through the stroke without harshness, supporting rider confidence across varied surfaces.

Who this shock is for

Suited to riders who want a more controlled, planted feel from the rear of their Foresight FEZ 250. Ideal if you are chasing improved composure during braking, cornering and acceleration compared with a tired or underdamped original unit.

Shock design & features

This model is a gas-charged, emulsion-style monotube shock design, using a single tube with the damping piston working in an oil and gas environment. The architecture is intended to keep damping response consistent and reduce fade during sustained use.

Tuning controls

This shock provides damping adjustment for both compression and rebound, allowing you to tailor support and control to your load, road conditions and riding preference. Spring preload adjustment is also used to set ride height and balance with rider weight.

Before you install

  • Confirm fitment for Honda Foresight FEZ 250 and rear mono position before purchase.
  • Set sag with correct preload before fine-tuning compression and rebound.
  • Check mounting hardware condition and torque settings during installation.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO839
Model # S36E
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 400.0
Spring Rate Standard 15.0 - 24.0 N/mm Progressive
Type Code S36E
Stroke Metal to Metal (mm) 125.0
Product Family STX 36 Scooter
Fitted Spring 00480-11
Spring Colour Yellow

More From This Category