The Ohlins STX 36 Twin rear shock set is designed as a twin-shock replacement for the Suzuki GSX 400 E (1982-on). Built around Ohlins’ proven 36 mm architecture, it targets consistent damping feel and controlled chassis behaviour on the road. This unit uses an emulsion-style oil and gas layout.

Ohlins | Made to race, perfected to ride

Ohlins street shocks are engineered for predictable control and long-term tuneability. The STX 36 Twin family focuses on balanced damping response suited to classic twin-shock motorcycles.

Who this shock is for

  • Riders restoring or upgrading a twin-shock Suzuki GSX 400 E and wanting a serviceable, tuneable rear suspension solution.
  • Owners looking for improved compliance and stability for everyday road riding.

Shock design & features

  • STX 36 Twin configuration for rear twin-shock fitment.
  • Emulsion damping layout (oil and gas in the same working volume).
  • Supplied with an Ohlins spring fitted from factory.

Tuning controls

  • Rebound damping adjustment
  • Spring preload adjustment

Before you install

  • Confirm eye-to-eye length and mounting style match your model and any modified hardware.
  • Set sag with preload first, then refine rebound damping to suit your tyre choice, load and riding pace.

Serviceability/lifecycle

Ohlins shocks are designed to be serviced to maintain damping performance over time. Regular inspection and periodic servicing will help keep the shock operating as intended.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU SU324E
Model # S36E
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 327.0
Spring Rate Standard 12.0 - 19.0 N/mm Progressive
Type Code S36E
Stroke Metal to Metal (mm) 92.0
Product Family STX 36 Twin
Fitted Spring 00480-02

More From This Category