The Ohlins STX 46 Street rear shock is built to improve suspension control and consistency on the Kawasaki Z 1000. Designed for road use with Ohlins race-developed damping know-how, it focuses on clearer feedback and more stable chassis behaviour. This unit uses a gas-pressurised damping system to help maintain consistent performance across varied conditions.

Ohlins | Made to race, perfected to ride

Ohlins street suspension is engineered to provide predictable support and refined damping feel for real-world riding. The STX 46 Street platform is intended to sharpen control without compromising day-to-day usability.

Who this shock is for

Suited to Kawasaki Z 1000 riders who want more stability and composure than a standard rear shock can deliver. It’s aimed at riders who value confidence under braking and smoother drive out of corners, and who want the option to tune damping to match load and riding style.

Shock design & features

This is a gas-pressurised, oil/gas separated rear mono shock design (not an emulsion type). The architecture is intended to support consistent damping behaviour and clear tyre contact feel across a wide range of road conditions.

Tuning controls

This shock provides rebound damping adjustment. Use rebound adjustment to fine-tune how quickly the rear returns after a bump or after weight transfer events such as braking and corner exit.

Before you install

  • Confirm the application is correct for your Kawasaki Z 1000 and that all supplied parts match your fitment requirements.
  • Check clearances around the shock body and any hose/reservoir routing (where applicable), and inspect linkage and bearings for wear before fitting.
  • After installation, set sag and verify damping settings suit your typical load (solo, luggage, or pillion).

Serviceability/lifecycle

Ohlins shocks are designed to be serviceable. Regular inspection and periodic servicing help maintain damping consistency and component life, particularly if the bike sees frequent hard use or poor road surfaces.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA155
Model # S46DR1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 338.0
Spring Rate Standard 100.0 N/mm
Type Code S46DR1
Stroke Metal to Metal (mm) 60.0
Product Family STX 46 Street
Notes Type S46DR1
Fitted Spring 01095-34
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category