The Ohlins STX 46 Street rear shock for the Kawasaki Versys 650 is built for riders who want more controlled suspension behaviour in real road conditions. It is designed to improve chassis stability and tyre contact when the pace changes or the surface gets rough. This unit uses a gas-pressurised layout to help maintain consistent damping over longer rides.

Ohlins | Made to race, perfected to ride

Developed from Ohlins suspension know-how, the STX 46 Street range focuses on predictable damping and reliable control for street use. On the Versys 650, it targets improved stability and confidence without turning the bike into something harsh or nervous.

Shock design & features

This is a gas-pressurised monotube rear shock using an STX 46 Street architecture. The gas and oil are not a simple emulsion mix, helping the shock stay consistent as it works through repeated impacts and heat cycles.

Tuning controls

This rear shock provides rebound damping adjustment so you can tailor how quickly the suspension extends after a bump or corner load. Rebound tuning is a practical way to match the feel to your riding style and typical load, helping the bike settle cleanly between turns and over uneven surfaces.

Is it right for you?

This unit suits Versys 650 riders who want a quality rear shock with external rebound adjustment and a gas-pressurised monotube design. If you mainly want a straightforward improvement in damping control and stability over the standard rear end, it is a sensible fit.

Before you install

  • Confirm this listing matches your Kawasaki Versys 650 application and mounting configuration before ordering.
  • After installation, set sag and check clearances through full suspension travel.
  • Plan to re-check settings after a few rides once the spring and bushings have settled.

Serviceability/lifecycle

Ohlins shocks are designed to be maintained. Periodic servicing helps keep damping performance consistent and extends the working life of seals and internal components.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA713
Model # S46DR1
Barcode # KA713
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 300.0
Spring Rate Standard 170.0 N/mm
Type Code S46DR1
Stroke Metal to Metal (mm) 50.0
Product Family STX 46 Street
Fitted Spring 01093-69
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category