The Ohlins KA935 STX 36 twin rear shocks are built to improve ride control and consistency on the Kawasaki VN 1500 Classic. This is a matched pair designed for street use, focusing on stable damping behaviour and predictable chassis response. As with any suspension change, correct setup for your load and riding conditions is key.

Ohlins | Made to race, perfected to ride

Ohlins twin-shock units apply proven damping design to real-world road riding. The aim is controlled movement through bumps, braking and cornering without harshness, helping the bike track cleanly and stay composed.

Shock design & features

  • STX 36 twin-shock rear configuration for the VN 1500 Classic
  • Gas-pressurised damping to maintain consistent performance as conditions change
  • Separate damping circuits for clearer control over suspension response

Tuning controls

These rear shocks provide external damping adjustment so you can tune how the suspension reacts across different roads and riding styles. They also support spring preload adjustment to suit rider weight, passenger use and luggage.

Before you install

  • Confirm fitment for Kawasaki VN 1500 Classic and that you are replacing a rear twin-shock setup
  • Set sag and preload before making damping changes, then fine-tune damping in small steps
  • Inspect linkage/ mounts and replace worn hardware to get the full benefit of the new shocks

Serviceability/lifecycle

Ohlins shocks are designed to be maintained rather than discarded. Regular servicing helps keep damping consistent and protects internal components, particularly if the bike sees frequent use or harsh conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA935
Model # S36K
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 320.0
Type Code S36K
Stroke Metal to Metal (mm) 79.0
Product Family STX 36 Twin
Fitted Spring 03195-08

More From This Category