The Ohlins STX 36 twin shock for the Kawasaki ZRX 1200 is built for riders who want consistent damping control and clear chassis feedback on the road. Based on Ohlins racing development, it focuses on predictable grip and stability across changing surfaces and loads. This unit uses a pressurised gas design to help maintain damping consistency during extended riding.

Ohlins | Made to race, perfected to ride

Ohlins suspension development is grounded in repeatable damping behaviour and tuneability. The STX 36 twin shock format suits classic twin-shock chassis layouts while bringing modern internal damping control to the rear end.

Who this shock is for

  • ZRX 1200 owners chasing improved rear stability and traction for spirited street riding
  • Riders who want a higher level of tuneability than a basic twin shock
  • Anyone looking to refine comfort and control without changing the character of the bike

Shock design & features

  • STX 36 twin-shock architecture developed from Ohlins performance applications
  • Pressurised gas damping system designed to reduce fade and keep behaviour consistent
  • Separate damping circuits for compression and rebound to support more precise tuning

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Spring preload adjustment

Before you install

  • Confirm clearance around the twin shocks, chain run, and rear brake components during full suspension travel
  • Set sag and baseline damping after installation before making fine changes
  • If you change load (luggage or pillion), revisit preload and damping to suit

Serviceability/lifecycle

Like all performance suspension, this shock is designed to be serviced to keep damping consistent over time. Regular inspection for leaks, bushing wear, and changes in feel will help determine when a refresh is due.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA417
Model # S36PR1C1L
Barcode # KA417
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 365.0 +8/-2
Spring Rate Standard 20.3 - 28.6 N/mm Progressive
Type Code S36PR1C1L
Stroke Metal to Metal (mm) 92.0
Product Family STX 36 Twin
Fitted Spring 00480-33
Spring Colour Yellow

More From This Category