The Ohlins STX 46 Street rear shock is built for riders who want more composed damping control and clearer chassis feedback on the road. It’s designed to maintain consistent behaviour as conditions change, helping the rear tyre stay settled through braking, cornering and drive. This unit is a rear mono-shock application for Moto-Guzzi Ghezzi & Brian models.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing know-how and adapted for street use, the STX 46 Street range focuses on predictable damping and practical adjustability. The aim is controlled movement, improved stability and confidence, without making the bike harsh or nervous.

Who this shock is for

  • Street riders chasing a more planted rear end and better control over mid-corner bumps
  • Owners looking to tune the bike for different tyres, loads or riding pace
  • Riders who want a quality serviceable shock rather than a sealed, disposable unit

Shock design & features

This is an oil/gas separated rear shock design intended to reduce aeration and maintain consistent damping. The architecture supports stable performance over longer rides and repeated hard use, with damping behaviour that remains easier to tune and repeat.

Tuning controls

Adjustment is provided for rebound damping and compression damping. These controls let you balance support and comfort, fine-tune grip and stability, and match the shock’s behaviour to your riding style and road conditions.

Before you install

  • Set sag and spring preload to suit rider weight and typical load before chasing damping changes
  • Record your starting positions so you can return to a known baseline after testing
  • If fitting alongside other chassis changes, adjust in small steps and test one change at a time

Serviceability/lifecycle

Like all performance shocks, routine servicing helps maintain damping consistency and protects internal parts from wear and contamination. Keeping to a sensible service interval based on use conditions will preserve performance and extend component life.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU MG124
Model # S46PR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 295.0
Spring Rate Standard 105.0 N/mm
Type Code S46PR1C1
Stroke Metal to Metal (mm) 56.0
Product Family STX 46 Street
Fitted Spring 01093-36
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category