The Ohlins STX 36 scooter front shock is built for riders who want clearer feedback and more controlled suspension behaviour from the front end. It is a gas-pressurised, oil/gas separated design intended to keep damping consistent during repeated braking and cornering loads. This unit suits the Vespa Elettrica, Primavera 150 and Sprint 150 ABS applications listed for this model.

Ohlins | Made to race, perfected to ride

Developed from Ohlins race-derived suspension know-how, this front shock focuses on stability, grip and predictability. The aim is better chassis control with a more planted feel through changing road surfaces.

Who this shock is for

  • Riders who want improved front-end support and feel under braking
  • Owners chasing more consistent handling through corners
  • Daily street use where comfort and control both matter

Shock design & features

  • STX 36 scooter shock architecture
  • Gas-pressurised, oil/gas separated damping to help reduce fade
  • Valving designed to improve control and feedback from the front tyre

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment

Before you install

  • Confirm correct mounting position: front mono
  • Check clearance around brake lines, guards and chassis components after fitment
  • Inspect mounting hardware condition and torque to the scooter manufacturer’s requirements

Serviceability/lifecycle

As an Ohlins unit, this shock is designed to be serviced to maintain damping performance over time. Regular inspection and periodic servicing will help keep the front end consistent as oil condition and seals age.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU PI801
Model # S36P
Barcode # PI801
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front Mono
Shock Length Eye to Eye (mm) 263.0
Spring Rate Standard 20.0 - 28.0 N/mm Progressive
Type Code S36P
Stroke Metal to Metal (mm) 72.0
Product Family STX 36 Scooter
Notes Front
Fitted Spring 60480-14
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category