The Ohlins STX 36 Blackline front shock for Vespa GTS 300 is built to improve control and ride quality through more consistent damping. It’s designed for riders who want a more settled front end without compromising the scooter’s classic look. As an Ohlins unit, it focuses on stability and feedback across everyday road conditions.

Ohlins | Made to race, perfected to ride

Developed from Ohlins suspension know-how, the STX 36 Blackline range pairs modern damping performance with a finish suited to classic and custom builds. The aim is predictable response and improved front-end composure under braking and over rough surfaces.

Who this shock is for

  • Vespa GTS 300 riders looking for a more controlled, stable front end
  • Owners who want a quality suspension upgrade that suits vintage or custom styling
  • Riders who value tunability to match load, tyre choice, and road conditions

Shock design & features

This is a gas-pressurised monotube shock design intended to keep damping consistent as conditions change. The Blackline finish is intended to complement classic aesthetics while delivering modern suspension function.

Tuning controls

This unit provides external adjustment for spring preload and damping, allowing you to tailor feel and support. It includes compression and rebound damping adjustment, so you can balance comfort, steering stability, and control to suit your riding.

Before you install

  • Confirm fitment for your Vespa GTS 300 and check mounting hardware condition during installation.
  • After installation, set baseline preload and damping, then fine-tune after a short test ride.
  • For best results, adjust one circuit at a time (rebound or compression) and document your changes.

Serviceability/lifecycle

Ohlins shocks are designed to be serviced to maintain damping performance over time. Periodic inspection and servicing helps keep the ride consistent and protects internal components, especially if the scooter is used regularly or on rough roads.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU PI411
Model # S36P (B)
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front
Shock Length Eye to Eye (mm) 279.0
Spring Rate Standard 12.5 - 16.2 N/mm Progressive
Type Code S36P (B)
Stroke Metal to Metal (mm) 81.0
Product Family STX 36 Blackline
Fitted Spring 60240-32
Rec. Ohlins Oil 01309-

More From This Category