The Ohlins HO243 STX 36 rear shock pair is built for Honda SH 350 riders who want more controlled suspension behaviour without compromising everyday usability. Developed from Ohlins road and race suspension know-how, it is designed to deliver consistent damping and clearer chassis feedback. This is a gas-pressurised, oil/gas separated design intended to maintain performance over longer rides.

Ohlins | Made to race, perfected to ride

Ohlins focuses on stability, grip and predictability through well-resolved damping control and quality internal components. The STX 36 scooter platform is designed to suit real-world road conditions while still offering meaningful adjustability.

Who this shock is for

  • Honda SH 350 owners looking for improved rear-end control and confidence, especially when braking and changing direction.
  • Riders who carry varying loads and want the ability to tune suspension feel rather than live with a fixed setting.
  • Those chasing consistent damping behaviour from a gas-pressurised rear shock pair.

Shock design & features

  • STX 36 scooter rear shock pair configuration.
  • Gas-pressurised damping with oil/gas separation to help reduce fade and keep damping consistent.
  • Valving designed to support traction and stability for road use.

Tuning controls

  • Rebound damping adjustment.
  • Compression damping adjustment.

Before you install

  • Rear twin-shock fitment for Honda SH 350.
  • Supplied with fitted spring 66396-01, with alternative spring 66396-02 included in the box (per notes).
  • Set sag and confirm clearance through full suspension travel after installation.

Serviceability/lifecycle

As with other Ohlins units, these shocks are designed to be serviced to maintain damping performance over time. Routine inspection and periodic servicing helps keep the oil condition and seal integrity in spec.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO243
Model # S36PR1C1
Barcode # HO243
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 401.5
Spring Rate Standard 10.0 - 13.0 N/mm Progressive
Spring Rate TBA
Type Code S36PR1C1
Stroke Metal to Metal (mm) 115.5
Product Family STX 36 Scooter
Notes Alternative spring 66396-02 in box
Fitted Spring 66396-01
Rec. Ohlins Oil 01309-

More From This Category