The Ohlins YA004 STX 36 rear scooter shock is built to improve control and consistency on the Yamaha YP 250 Majesty. Developed from Ohlins suspension know-how, it focuses on stable damping behaviour and predictable chassis response. The design uses a gas-pressurised internal layout to help maintain damping performance through extended use.

Ohlins | Made to race, perfected to ride

Ohlins products are engineered around repeatable damping control and rider feedback. This rear unit is intended to provide a more composed feel under braking, through turns, and when accelerating out of corners.

Shock design & features

  • Gas-pressurised, emulsion-style internal design to support consistent damping behaviour
  • Ohlins STX 36 architecture aimed at improving traction and stability
  • Rear fitment for Yamaha YP 250 Majesty

Tuning controls

This shock provides external adjustment to tune damping for riding conditions and rider preference. It includes rebound adjustment and compression adjustment, allowing you to refine stability, comfort, and grip balance.

Base setup (factory preset)

The shock is supplied with an Ohlins baseline setting intended as a starting point. From there, adjustments can be made to suit load, road conditions, and the feel you prefer.

Before you install

  • Confirm correct fitment for Yamaha YP 250 Majesty and the rear mounting arrangement
  • Inspect mounting hardware and bearings/bushes for wear before installation
  • After installation, check clearances and re-torque fasteners as required

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA004
Model # S36E
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 346.0
Spring Rate Standard 10.0 N/mm
Type Code S36E
Stroke Metal to Metal (mm) 101.0
Product Family STX 36 Adventure
Fitted Spring 00280-10

More From This Category