The Ohlins STX 36 rear scooter shock for Honda Click 150 is a gas-charged mono shock designed to improve damping control and ride confidence in real-world use. It uses Ohlins-developed valving architecture to support traction and stability as conditions change. Built for tuning and serviceability, it suits riders who want more control than a basic replacement unit.

Ohlins | Made to race, perfected to ride

STX 36 scooter shocks bring Ohlins suspension know-how into a compact rear shock format for modern scooters. The focus is consistent damping behaviour and clear chassis feedback without adding complexity where it is not needed.

Who this shock is for

Suited to Honda Click 150 owners who ride daily and want improved composure under braking, cornering and uneven road surfaces. It also fits riders who carry varying loads and want a shock that can be tuned to match their use.

Shock design & features

This is a gas-pressurised shock with oil and gas separated to help maintain consistent damping during extended riding. The STX 36 layout is intended to reduce fade and keep response predictable as the shock temperature changes.

Tuning controls

The HO831 provides adjustable rebound and adjustable compression damping, allowing you to balance comfort, support and traction. It also includes spring preload adjustment so ride height and sag can be set to suit rider weight and load.

Before you install

Check overall condition of linkage, swingarm bearings and mounting hardware before fitting, as worn components can mask suspension improvements. After installation, set sag and then fine-tune rebound and compression to suit your typical roads and riding pace.

Serviceability/lifecycle

This Ohlins unit is designed to be serviced to maintain performance over time. Periodic oil and seal service helps keep damping consistent and extends component life.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO831
Model # S36PR1C1
Barcode # HO831
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 333.0
Spring Rate Standard 8.0 - 18.0 N/mm Progressive
Type Code S36PR1C1
Stroke Metal to Metal (mm) 85.0
Product Family STX 36 Scooter
Fitted Spring 60360-08
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category