The Ohlins STX 36 Blackline front shock for Vespa GTS 300/150 is built to improve suspension control and ride consistency in everyday scooter use. It combines modern damping hardware with a classic Blackline finish suited to original or custom styling. Designed as a single front unit, it provides practical tuning range without adding complexity.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on predictable damping behaviour and long-term serviceability. The STX platform is intended to deliver a controlled, settled ride across varied road surfaces while keeping the scooter responsive and stable.

Shock design & features

This is an oil/gas separated shock design rather than an emulsion layout, helping maintain damping consistency as temperatures and operating conditions change. The Blackline finish is suited to riders who want an understated appearance without compromising on component quality.

Tuning controls

Adjustability includes spring preload, rebound damping, and compression damping. These controls let you tailor support, comfort and chassis attitude for rider load, tyre choice and typical road conditions.

Who this shock is for

Suited to Vespa GTS 300 and GTS 150 owners wanting more controlled front-end behaviour than standard suspension, especially when braking, cornering or riding over uneven surfaces. It’s also a good match for riders building a classic-look scooter that still benefits from modern damping performance.

Before you install

  • Confirm fitment for your exact Vespa model and year within the GTS 300/150 range.
  • Inspect the front suspension mounts and fasteners for wear before installation.
  • After fitting, re-check fastener torque and set sag/preload to suit your typical riding load.

Serviceability/lifecycle

Ohlins units are designed to be maintained over time. Regular servicing helps keep damping performance consistent and can extend component life, particularly for scooters used daily or in wet and dirty conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU PI911
Model # S36P (B)
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front Mono
Shock Length Eye to Eye (mm) 272.5
Spring Rate Standard 19.0 - 27.0 N/mm Progressive
Type Code S36P (B)
Stroke Metal to Metal (mm) 81.5
Product Family STX 36 Blackline
Notes Front
Fitted Spring 60001-15
Rec. Ohlins Oil 01309-

More From This Category