The Ohlins STX 36 rear shock pair for the Honda Air Blade 125 is built to improve suspension control and consistency in everyday riding. Designed around a gas-pressurised, oil/gas separated layout, it helps maintain damping stability as conditions change. With external adjustment for key damping circuits, it allows you to tailor feel for comfort, grip and chassis balance.

Ohlins | Made to race, perfected to ride

Ohlins scooter shocks are developed with a focus on damping quality and repeatability. The STX 36 platform is intended to deliver clearer feedback from the rear tyre and more predictable response through braking, turns and acceleration.

Shock design & features

  • Rear twin-shock application for the Honda Air Blade 125
  • Gas-pressurised, oil/gas separated design to support consistent damping
  • STX 36 Scooter product family architecture

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Spring preload adjustment

Base setup (factory preset)

These shocks are supplied with an Ohlins baseline setting intended as a starting point. Use preload to set ride height and balance, then refine with compression and rebound to suit load, road surface and riding style.

Before you install

  • Confirm model compatibility for Honda Air Blade 125 and rear twin mounting
  • Inspect linkage/mount hardware condition and replace worn bushes or fasteners as required
  • After installation, re-check all fasteners after the first rides

Serviceability/lifecycle

Ohlins units are designed to be serviced to maintain performance over time. Periodic inspection and fresh oil/seals will help keep damping consistent, particularly if the scooter is used frequently or in harsh conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO743
Model # S36PR1C1
Barcode # HO743
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 328.0
Spring Rate Standard 15.0 - 24.0 N/mm Progressive
Type Code S36PR1C1
Stroke Metal to Metal (mm) 85.0
Product Family STX 36 Scooter
Fitted Spring 60360-03
Rec. Ohlins Oil 01309-

More From This Category