The Ohlins STX 36 rear shock for the Honda MSX 125 range is built to improve rear-wheel control and chassis stability in real-world riding. It is a gas-pressurised design intended to keep damping consistent as conditions and pace change. This unit suits riders who want clearer feedback and more controlled suspension behaviour than a basic stock shock.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing know-how, the STX platform focuses on predictable damping response and usable adjustment. On a small-capacity chassis like the MSX 125 (including Grom and USA-Grom SF), that translates to better composure through corners and under braking.

Who this shock is for

  • Honda MSX 125 owners (including Grom and USA-Grom SF) wanting more stability and grip from the rear end
  • Riders who value tunability to match road conditions, load and riding style
  • Anyone chasing more consistent damping performance during longer or harder rides

Shock design & features

  • STX 36 architecture with gas-pressurised damping to help reduce fade
  • Rear mono shock configuration for the MSX 125 platform
  • Designed to deliver improved traction and controlled chassis response

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment

Before you install

  • Confirm model compatibility for your specific MSX 125/Grom variant before fitting
  • Set sag and baseline adjustments after installation to suit rider weight and use
  • Note: an extra optional spring is supplied in the box (as listed in the product notes)

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO611
Model # S36HR1C1
Barcode # HO611
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 244.0
Spring Rate Standard 100.0 N/mm
Spring Rate TBA
Type Code S36HR1C1
Stroke Metal to Metal (mm) 43.0
Product Family STX 36 Scooter
Notes Extra optional spring in box 60282-06 (110 N/mm)
Fitted Spring 60281-08

More From This Category