The Ohlins STX 36 rear shock pair for Vespa GTS 300 and GTS 150 is designed to deliver controlled damping and clear chassis feedback for everyday road use. Supplied as a matched left and right set for rear twin-shock applications, it focuses on stability and consistent response across a wide range of conditions. This model uses a gas-charged internal design to help maintain damping consistency in use.

Ohlins | Made to race, perfected to ride

Built around Ohlins scooter-specific STX 36 architecture, this rear pair aims to improve composure through braking, cornering and uneven surfaces without compromising ride quality. The design supports repeatable performance for riders who want a more controlled, predictable suspension feel.

Shock design & features

  • STX 36 scooter rear shock pair for rear twin-shock fitment
  • Gas-charged emulsion-style construction (internal gas and oil mixture)
  • Matched left and right units for the Vespa GTS platform

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment

Base setup (factory preset)

These shocks are supplied with an Ohlins baseline setting intended as a starting point for road riding. Fine-tuning is typically done to suit rider load, scooter setup and preferred feel.

Before you install

  • Rear twin-shock fitment for Vespa GTS 300 and GTS 150
  • Optional springs and component brackets are supplied in the box and are recommended for GTS 150 applications
  • Confirm you have the correct springs and hardware for your model before installation

Serviceability/lifecycle

As an Ohlins unit, the shocks are designed to be serviced to maintain performance over time. Periodic inspection and oil service will help keep damping consistent as kilometres and operating conditions accumulate.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU PI903
Model # S36E
Barcode # PI903
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) RH 324.0 LH 328.0
Spring Rate Standard 14.2 - 21.1 N/mm Progressive
Spring Rate TBA
Type Code S36E
Stroke Metal to Metal (mm) RH 84.0 LH 88.0
Product Family STX 36 Scooter
Notes Optional springs 60360-04 and component brackets supplied in the box recommended for GTS 150
Fitted Spring 60360-03
Rec. Ohlins Oil 01309-

More From This Category