The Ohlins TTX 44 rear shock for the Yamaha YZ 250F is built around Ohlins’ twin-tube damping architecture for consistent control across changing track conditions. It is a gas-pressurised, oil/gas separated design intended for riders who want predictable damping and clear chassis feedback. Supplied without a spring, it is designed to be matched with the correct spring for your weight and use.

Ohlins | Made to race, perfected to ride

TTX technology is developed from competition use and focuses on maintaining stable damping behaviour under repeated impacts. The twin-tube layout promotes controlled oil flow through the damping circuits, supporting traction and stability through braking bumps, ruts, and corner exits.

Who this shock is for

Suited to YZ 250F riders wanting a dedicated performance rear shock with broad tuning scope for motocross and related off-road riding. It’s also a good fit when you’re chasing improved rear-end control and a more settled feel as pace increases.

Shock design & features

  • Twin-tube (TTX) rear mono shock architecture
  • Gas-pressurised, oil/gas separated damping for consistency in demanding use
  • Designed for spring selection to suit the rider (spring not supplied)

Tuning controls

This shock provides external compression and rebound damping adjustment, allowing you to balance support, traction and recovery speed to match track conditions and riding style.

Before you install

  • Confirm the correct spring selection is ordered separately as required for your setup
  • Set sag and clicker positions from the Ohlins baseline, then tune in small steps
  • Inspect linkage bearings and mounting hardware condition during installation

Serviceability/lifecycle

Like all performance shocks, regular servicing helps maintain damping consistency and seal life. Plan service intervals around hours of use and the conditions you ride in, especially if you regularly encounter mud, dust, or high-impact tracks.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA1693
Model # T44PR1C2W
Barcode # YA1693
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 458.0
Spring Rate No Spring/s Supplied
Type Code T44PR1C2W
Stroke Metal to Metal (mm) 121.0
Product Family TTX 44
Notes 06310- series spring
Fitted Spring Sold separately, see notes.

More From This Category