The Ohlins STX 36 rear shock for the Yamaha Fazzio 125 is built around proven Ohlins damping architecture to improve control and consistency in everyday scooter use. It’s designed to deliver clear chassis feedback and more stable behaviour through braking, cornering and acceleration. This unit uses a gas-pressurised, oil/gas separated design to help maintain damping performance over varied road conditions.

Ohlins | Made to race, perfected to ride

Developed from Ohlins competition experience, the STX 36 scooter platform is focused on predictable damping and practical adjustability. The aim is better traction and stability without compromising ride quality on typical urban and suburban surfaces.

Who this shock is for

Suited to Yamaha Fazzio 125 riders who want a more controlled rear end than a standard shock can offer. It’s a good match for riders who notice wallow, harshness, or inconsistent feel as speeds increase, road quality deteriorates, or loads vary.

Shock design & features

  • STX 36 scooter rear shock platform
  • Gas-pressurised damping with oil/gas separation for more consistent performance
  • Damping layout intended to improve traction and stability, particularly under braking and during corner transitions

Tuning controls

This rear shock includes external damping adjustment for compression and rebound, allowing you to tune response to road conditions and riding preference. Independent circuits provide a clearer change in feel when you make adjustments, helping you dial in support and comfort more accurately.

Before you install

  • Confirm fitment for Yamaha Fazzio 125 and check clearance around the shock body and reservoir arrangement (if applicable on your model).
  • Set sag and verify fastener torque to the scooter manufacturer’s requirements.
  • After initial rides, re-check mounting hardware and review your damping settings to suit your typical route and load.

Serviceability/lifecycle

Like other Ohlins units, this shock is designed to be serviced to maintain performance over time. Regular inspection and periodic servicing helps keep damping consistent and protects internal components, especially in wet or dusty use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA315
Model # S36PC1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 316.5
Spring Rate Standard 22.0 - 40.0 N/mm Progressive
Type Code S36PC1
Stroke Metal to Metal (mm) 84.5
Product Family STX 36 Scooter
Fitted Spring 66380-09
Rec. Ohlins Oil 01309-

More From This Category