The Ohlins STX 46 Street rear shock for the Yamaha FZS 1000 Fazer is built for riders who want consistent damping control and clear chassis feedback on real roads. It uses a pressurised, oil/gas-separated design to help maintain damping performance as conditions change. The internal layout is focused on predictable support under braking and stability through corners.

Ohlins | Made to race, perfected to ride

Developed from Ohlins race heritage, this unit is tuned to deliver controlled comfort and confidence for fast street riding. The emphasis is on consistency, traction and stable geometry rather than harshness.

Who this shock is for

  • Street riders looking for a more controlled rear end with improved feel and stability
  • Owners who want adjustable damping to suit load, tyres and road conditions
  • Riders who prefer a quality replacement shock rather than a reworked original

Shock design & features

This rear mono shock is an oil/gas-separated, pressurised design intended to reduce damping fade and keep behaviour consistent. The STX architecture focuses on stable, repeatable damping characteristics with clear feedback at the rear contact patch.

Tuning controls

  • Rebound damping adjustment
  • Spring preload adjustment

Before you install

  • Confirm fitment for Yamaha FZS 1000 Fazer and check clearance around the linkage and reservoir area during installation
  • Set sag and baseline adjuster positions after installation so the shock works in the correct part of its travel
  • If you regularly carry a passenger or luggage, plan on setting preload to suit your usual load

Serviceability/lifecycle

Like all performance shocks, periodic servicing helps maintain damping consistency and seal life. Keeping the unit clean and addressing oil leaks or unusual behaviour early will extend service life and preserve performance.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA313
Model # S46ER1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 305.5
Spring Rate Standard 85.0 N/mm
Type Code S46ER1
Stroke Metal to Metal (mm) 65.5
Product Family STX 46 Street
Fitted Spring 01091-26
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category