The Ohlins YA426 is a rear STX 36 twin shock unit designed for the Yamaha V-Max. Built around Ohlins’ proven piston and valve architecture, it is intended to deliver controlled damping behaviour across a wide range of road conditions. The design uses separated oil and gas to help maintain consistent performance during longer or harder rides.

Ohlins | Made to race, perfected to ride

STX technology focuses on predictable damping response and stable chassis behaviour. This twin-shock layout suits the V-Max’s rear suspension arrangement and supports confident set-up changes without compromising ride quality.

Who this shock is for

  • Riders refreshing worn rear suspension and wanting a higher-quality, tunable damper.
  • Street riders who value stability, traction, and consistent control in varied conditions.
  • Owners who want a suspension baseline that can be tailored to load, tyres, and riding style.

Shock design & features

  • STX 36 twin-shock architecture for controlled, repeatable damping response.
  • Oil/gas separated internal design to support consistency as temperatures rise.
  • Built for rear fitment in a twin-shock configuration.

Tuning controls

  • Rebound damping adjustment to manage how the rear settles and recovers after bumps.
  • Compression damping adjustment to tune support under acceleration, braking forces, and sharper impacts.

Before you install

  • Confirm compatibility with your exact Yamaha V-Max model and year before fitting.
  • After installation, set sag and verify clearances through full suspension travel.
  • If changing load or riding style, revisit damping settings to keep balance front-to-rear.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA426
Model # S36PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 324.0 +10/-0
Spring Rate Standard 18.0 - 27.0 N/mm Progressive
Type Code S36PR1C1L
Stroke Metal to Metal (mm) 87.0
Product Family STX 36 Twin
Fitted Spring 00380-05
Spring Colour Yellow

More From This Category