The Ohlins YA557 STX 36 Twin rear shock package is built for the Yamaha XJR 1300 and suited to riders who want more composure, grip and feel from the back of the bike. It uses a pressurised damping design to keep damping consistent as conditions change. Adjustment is provided for rebound and compression damping, plus length for ride-height tuning.

Ohlins | Made to race, perfected to ride

Ohlins street shocks draw on race-developed damping knowledge, then are configured for real-road use. The result is improved control through corners, better traction on exit, and more stable behaviour under load changes.

Shock design & features

  • STX 36 Twin rear shock configuration for twin-shock applications
  • Pressurised oil/gas design (not an emulsion shock) to support consistent damping
  • Supplied with matched springs as fitted by Ohlins for this application

Tuning controls

  • Rebound damping adjustment to manage return speed after bumps and load transfer
  • Compression damping adjustment to control squat and support under acceleration and braking
  • Length adjustment to fine-tune rear ride height and chassis attitude

Base setup (factory preset)

This unit is delivered with an Ohlins baseline setup intended to be a safe starting point for the XJR 1300. From there, fine adjustment can be made to match tyres, load, road surface and rider preference.

Before you install

  • Confirm correct fitment for your Yamaha XJR 1300 model and year, and check clearance around exhaust and guards
  • Set sag and verify full travel clearance before riding
  • After installation, re-check fasteners and alignment after the first rides

Serviceability/lifecycle

Ohlins shocks are designed to be serviceable so performance can be maintained over time. Periodic servicing helps keep damping consistent and protects internal components from wear and contamination.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA557
Model # S36PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 325.0 +10/-0
Spring Rate Standard 22.0 - 39.0 N/mm Progressive
Type Code S36PR1C1L
Stroke Metal to Metal (mm) 92.0
Product Family STX 36 Twin
Fitted Spring 00379-01

More From This Category