The Ohlins YA604 STX 36 twin rear shock set is built for the Yamaha XJR 1300, focusing on controlled damping and consistent feel across a wide range of road conditions. As a matched pair for twin-shock fitments, it’s aimed at improving chassis stability and traction without making the ride unpredictable. This unit uses a gas-pressurised design to help maintain damping consistency during longer rides.

Ohlins | Made to race, perfected to ride

Developed from Ohlins race experience, the STX 36 Twin platform is designed to deliver predictable feedback and stable handling. It’s a practical performance upgrade for riders who want a more controlled rear end and clearer tyre contact feel.

Who this shock is for

Suited to XJR 1300 riders who want improved support, stability and confidence from the rear suspension. It’s also a strong option if you regularly carry load or ride a mix of smooth and rougher roads and want a shock that can be tuned to suit.

Shock design & features

This is a twin-shock rear configuration using a gas-pressurised, oil/gas-separated layout to help reduce fade and maintain consistent damping. The STX 36 architecture is intended to provide stable control under braking and acceleration while improving rear tyre contact over changing surfaces.

Tuning controls

The YA604 provides external damping adjustment for both compression and rebound, allowing you to balance ride comfort, stability and grip to suit your riding conditions. It also includes spring preload adjustment to set sag correctly for your weight and typical load.

Before you install

  • Set rider sag and static sag first, then fine-tune damping in small steps.
  • Confirm clearance around chain, exhaust and bodywork through full suspension travel.
  • If your bike has non-standard linkage geometry or ride height changes, re-check setup after installation.

Serviceability/lifecycle

Ohlins shocks are designed to be serviced and reconditioned to maintain performance over time. Regular servicing helps keep damping consistent and allows internal wear items and fluid to be refreshed as needed.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA604
Model # S36P
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 325.0
Spring Rate Standard 18.0 - 27.0 N/mm Progressive
Type Code S36P
Stroke Metal to Metal (mm) 93.0
Product Family STX 36 Twin
Fitted Spring 00480-13
Spring Colour Yellow

More From This Category