The Ohlins STX 46 Street rear shock is built for riders who want a controlled, settled chassis on real roads. It uses a monotube layout with a separated oil and gas design to maintain consistent damping under repeated bumps and heat. Developed from Ohlins road and race experience, it focuses on predictable grip and clear feedback rather than a harsh ride.

Ohlins | Made to race, perfected to ride

STX technology is Ohlins’ street-focused approach to delivering stable, confidence-inspiring damping with straightforward adjustment. The design aims to keep the rear tyre working through changes in speed, surface and load, helping the bike stay composed mid-corner and on corner exit.

Who this shock is for

Suited to Yamaha FZ 1 riders who want improved traction, stability and damping control compared with a tired or basic standard unit. It’s a good match for commuting, weekend runs and brisk road riding where the suspension needs to cope with varying surfaces and braking loads.

Shock design & features

This is a rear mono shock using a gas-pressurised monotube architecture with oil and gas separated. The intent is to reduce cavitation and help damping consistency during longer or more demanding rides.

Tuning controls

Adjustment is provided for rebound damping and compression damping, allowing you to balance support and comfort to suit your riding style and conditions. Spring preload is also adjustable to set ride height and sag for rider weight and typical load.

Before you install

  • Confirm fitment for your exact Yamaha FZ 1 model and year.
  • Set sag and baseline adjusters after installation to match rider weight and typical luggage/passenger use.
  • If you’re not sure where to start, note your current handling symptoms (wallow, harshness, loss of grip) to guide initial tuning.

Serviceability/lifecycle

Like other Ohlins units, this shock is designed to be maintained and tuned over its life rather than treated as disposable. Periodic servicing helps keep damping consistent and protects internal wear components.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA628
Model # S46HR1C1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 320.5
Spring Rate Standard 120.0 N/mm
Type Code S46HR1C1S
Stroke Metal to Metal (mm) 67.5
Product Family STX 46 Street
Fitted Spring 01095-44
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category