The Ohlins YA789P TTX RT rear shock is built for Yamaha YZF R6 riders who want clear tyre feedback and repeatable damping on road or track. This unit uses the TTX twin-tube architecture to keep damping behaviour consistent as conditions change. It is a gas-pressurised, oil/gas separated design intended for stable performance under hard use.

Ohlins | Made to race, perfected to ride

Developed from Ohlins race programme experience, the TTX RT platform focuses on controlled chassis movement and predictable grip. The aim is to help the bike stay composed under braking, through direction changes, and when driving off the corner.

Who this shock is for

  • R6 riders doing track days or racing who need precise damping control and consistent feel
  • Road riders chasing improved stability and clearer feedback compared with a standard shock
  • Owners who want a serviceable performance shock with broad tuning range

Shock design & features

  • TTX twin-tube layout for balanced damping behaviour and repeatability
  • Gas-pressurised, oil/gas separated damping system to help maintain consistency during sustained running
  • Rear mono shock configuration for Yamaha YZF R6 fitment

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Length adjustment to fine-tune chassis attitude

Before you install

  • Set sag and balance front-to-rear before making damping changes
  • Confirm clearance and routing around the shock body and reservoir area during installation
  • Plan for periodic servicing to keep damping performance consistent over time

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA789P
Model # T36PR1C1LB
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 293.0 +5/-1
Spring Rate Standard 100.0 N/mm
Type Code T36PR1C1LB
Stroke Metal to Metal (mm) 60.0
Product Family TTX RT
Fitted Spring 21041-34

More From This Category