The Ohlins YA513 STX 36 twin rear shock is built for riders who want more controlled damping behaviour from the Yamaha V-Max without compromising ride quality. It uses a pressurised monotube layout to keep the damping consistent as conditions and temperature change. The result is a more settled chassis feel across acceleration, braking and cornering loads.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing know-how, the STX platform focuses on stable damping control and predictable feedback. This helps the rear tyre stay in contact with the road when the bike is working hard.

Who this shock is for

Suited to street riders who want sharper chassis control and the ability to tune the rear suspension to their riding style. It also makes sense for owners carrying varied loads or riding across mixed road surfaces where adjustability is valuable.

Shock design & features

This is a gas-pressurised monotube shock design rather than an emulsion-style unit, helping resist fade and maintain consistent damping. The STX 36 twin-shock format is intended for rear applications that use a pair of shocks.

Tuning controls

Adjustability includes compression damping and rebound damping, allowing you to balance support and comfort and refine how the rear recovers after bumps. Spring preload adjustment is also provided to set ride height and sag correctly for rider and load.

Before you install

  • Confirm fitment for the Yamaha V-Max twin-shock rear configuration.
  • Set sag and preload first, then fine-tune rebound and compression in small steps.
  • Plan periodic servicing to keep seals and oil in good condition and maintain consistent performance.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA513
Model # S36PCRAS
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 324.0 +10/-0
Spring Rate Standard 18.0 - 27.0 N/mm Progressive
Type Code S36PCRAS
Stroke Metal to Metal (mm) 87.0
Product Family STX 36 Twin
Fitted Spring 00380-05

More From This Category