The Ohlins YA325 STX 36 rear scooter shock is built to improve control and consistency on the Yamaha Grand Filano. It uses a gas-pressurised, oil/gas separated layout to help keep damping stable as conditions change. The result is a more controlled rear end feel through braking, turn-in and acceleration.

Ohlins | Made to race, perfected to ride

Developed from Ohlins suspension know-how, the STX 36 Scooter range focuses on predictable damping and dependable behaviour on the road. It is designed to support confident handling without making the ride feel vague or harsh.

Who this shock is for

Suited to riders who want better chassis control from the rear of their Grand Filano and the ability to fine-tune damping. It is a practical fit for daily riding where stability, traction and braking support matter.

Shock design & features

  • Gas-pressurised, oil/gas separated design to support consistent damping
  • Ohlins STX 36 Scooter shock architecture intended for controlled response and rear grip
  • Rear mono-shock application for the Yamaha Grand Filano

Tuning controls

This rear shock includes external adjustment for rebound damping and compression damping, allowing you to balance comfort, grip and chassis stability to suit your riding.

Before you install

  • Confirm motorcycle model and fitment details for the Yamaha Grand Filano before installation
  • Set sag and check that all fasteners are torqued to the vehicle manufacturer’s specifications
  • After initial ride time, re-check mounting hardware and reassess damping settings

Serviceability/lifecycle

Like all performance suspension, this Ohlins unit is designed to be serviced to maintain damping consistency over time. Regular inspection and periodic servicing will help keep performance predictable as oil and wear items age.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA325
Model # S36PR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 320.0
Spring Rate Standard 21.0 - 26.0 N/mm Progressive
Type Code S36PR1C1
Stroke Metal to Metal (mm) 92.0
Product Family STX 36 Scooter
Fitted Spring 60360-06
Rec. Ohlins Oil 01309-

More From This Category