The Ohlins STX 46 Street rear shock for Yamaha Niken/GT (MXT 850) is built to deliver consistent damping control and clear feedback on the road. The design focuses on traction, stability and predictable chassis behaviour across a wide range of riding conditions. It uses a gas-pressurised damping system to help maintain performance as temperatures and loads change.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing experience and adapted for real-world street use, this unit is aimed at riders who want a more controlled and confidence-inspiring rear end. The STX 46 Street platform is designed to provide consistent support without harshness, with damping behaviour that remains stable during longer rides.

Shock design & features

  • Gas-pressurised, oil/gas separated damping system for consistent operation
  • Rear mono-shock configuration for the Yamaha Niken/GT chassis layout
  • Valving intended to improve tyre contact and stability through cornering and braking loads

Tuning controls

  • Rebound damping adjustment to manage extension speed and traction feel
  • Compression damping adjustment to tune support under acceleration and braking
  • Spring preload adjustment to set ride height balance and sag for rider/load

Base setup (factory preset)

This shock is supplied with an Ohlins-fitted spring and a baseline tune set by Ohlins for the intended application. Final setup should be checked on the bike, as preload and damping requirements vary with rider weight, luggage and typical roads.

Before you install

  • Confirm fitment for Yamaha Niken/GT (MXT 850) before installation
  • Inspect linkage/bearings and mounting hardware condition during replacement
  • After installation, set sag via preload first, then fine-tune compression and rebound

Serviceability/lifecycle

Ohlins shocks are designed to be serviced and reconditioned as part of normal ownership. Periodic servicing helps keep damping consistency and seal performance over time, particularly if the bike sees frequent spirited use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA798
Model # S46HR1C1S
Barcode # YA798
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 323.5
Spring Rate Standard 120.0 N/mm
Type Code S46HR1C1S
Stroke Metal to Metal (mm) 62.5
Product Family STX 46 Street
Fitted Spring 01095-44
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category