The Ohlins KTM/Husqvarna Enduro (SET) is an Ohlins suspension unit package intended for KTM and Husqvarna enduro applications. Built around Ohlins engineering and quality control, it’s designed to deliver consistent damping behaviour and a predictable ride feel. Supplied as a set, it suits riders looking to refresh or improve their suspension with genuine Ohlins components.

Ohlins | Made to race, perfected to ride

Ohlins units are developed with a focus on controlled damping response and long-term durability. This set is built for off-road enduro use where traction, stability and feedback matter.

Who this set is for

  • Enduro riders wanting a matched Ohlins suspension set for KTM/Husqvarna.
  • Riders prioritising confidence, feel and consistency over changing conditions.
  • Those replacing tired suspension with a complete Ohlins package.

Shock design & features

This listing is supplied as an Ohlins set for KTM/Husqvarna enduro models. The exact internal design and feature set depend on the specific unit configuration under type code FCX301-20.

Tuning controls

Adjustment functions are model- and unit-specific. Refer to the Ohlins documentation for FCX301-20 to confirm available tuning controls and recommended adjustment procedure.

Before you install

  • Confirm correct fitment for your exact model, year and enduro variant before installation.
  • Inspect linkage, bearings and mounting hardware condition during installation.
  • After fitment, set sag and baseline adjustments in line with Ohlins guidance.

Serviceability/lifecycle

Ohlins suspension units are designed to be serviced to maintain performance over time. Follow Ohlins service intervals and use appropriate fluids and parts as specified for FCX301-20.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FCX301-20
Barcode # FCX30120
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Type Code S22DR1C1

More From This Category