The Ohlins ACE shock absorber set is designed for Kawasaki Zephyr 1100 fitment, supplied as a matched pair. Built with Ohlins’ focus on consistent damping control and long-term serviceability, it’s intended for riders who want a more controlled rear end without compromising ride quality. This listing uses only the provided product data, so adjustment and internal design details are not specified here.

Ohlins | Made to race, perfected to ride

Ohlins rear suspension units are engineered to deliver predictable damping behaviour and stable chassis support across real-world street conditions. The ACE series is aimed at refined control and repeatable performance with proper setup and maintenance.

Who this shock is for

  • Kawasaki Zephyr 1100 owners replacing worn or inconsistent rear shocks
  • Riders seeking improved stability and damping control for street riding
  • Builds where a matched left/right rear shock pair is required

Shock design & features

This product is supplied as a pair of Ohlins rear shock absorbers for street application. The provided input does not state whether the shocks are emulsion or feature separated oil/gas architecture, so that detail cannot be confirmed here.

Tuning controls

The input data does not specify which adjustments are present (for example rebound, compression, or spring preload). If you need confirmation of adjusters and configuration for your exact bike and model year, please check the packaging documentation or the official Ohlins fitment notes for this kit.

Serviceability/lifecycle

Ohlins units are designed to be serviceable to help maintain damping consistency over time. Regular inspection and periodic servicing are recommended, especially if the bike sees frequent use or poor road surfaces.

Before you install

  • Confirm exact Zephyr 1100 model and year compatibility prior to installation
  • Inspect mounting hardware and bushes during fitment and replace if worn
  • Set rider sag and confirm clearance through full suspension travel

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA448
Barcode # KA448
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

More From This Category